W
wizkid
Guest
Hi,
Thanks again for your response, and for confirming that UEFI and secure boot are now running ok.
I have had a play around with the USB drivers and downloaded the ones from the motherboards maker's site but these seem to offer lower performance in speeds than the latest Windows drivers, so I have removed the usb devices and am using the windows drivers at the moment and have not had a reoccurrence of the BSOD yet. I did notice yesterday that when looking through the logs in event viewer that it reported there is a controller issue with the Kingston Memory card reader, I have removed this device and the error message no longer shows up in there so I suspect it may have become faulty, I have swapped out the cable and tried in different ports etc but had no luck. Do you think that could possibly be the cause of the USB driver BSOD if the device was failing?
I've been in contact with Kingston regarding this and they advise that the card reader should be replaced, they advised that the firmware on their site for Windows 8 is also compatible with 8.1 but I am going to look into this further as the firmware was built prior to Windows 8.1 being released.
Do you know where I can obtain the latest LGBusEnum.sys driver from? I've downloaded the latest set point software from Logitech's website but the driver is still dated 2009..
Also do you recommend that I use the latest AMD Sata Controller driver? At the moment I am using the standard Windows Driver at the moment, I don't think there is any issue but I just wanted to check what you think is best to use?
Thanks again for your help.
Thanks again for your response, and for confirming that UEFI and secure boot are now running ok.
I have had a play around with the USB drivers and downloaded the ones from the motherboards maker's site but these seem to offer lower performance in speeds than the latest Windows drivers, so I have removed the usb devices and am using the windows drivers at the moment and have not had a reoccurrence of the BSOD yet. I did notice yesterday that when looking through the logs in event viewer that it reported there is a controller issue with the Kingston Memory card reader, I have removed this device and the error message no longer shows up in there so I suspect it may have become faulty, I have swapped out the cable and tried in different ports etc but had no luck. Do you think that could possibly be the cause of the USB driver BSOD if the device was failing?
I've been in contact with Kingston regarding this and they advise that the card reader should be replaced, they advised that the firmware on their site for Windows 8 is also compatible with 8.1 but I am going to look into this further as the firmware was built prior to Windows 8.1 being released.
Do you know where I can obtain the latest LGBusEnum.sys driver from? I've downloaded the latest set point software from Logitech's website but the driver is still dated 2009..
Also do you recommend that I use the latest AMD Sata Controller driver? At the moment I am using the standard Windows Driver at the moment, I don't think there is any issue but I just wanted to check what you think is best to use?
Thanks again for your help.
Last edited by a moderator: