Please visit Windows Update and install every update available, it may take a couple of times to get them all.
Please
uninstall Avast while troubleshooting
Code:
*** WARNING: Unable to verify timestamp for aswMonFlt.sys
*** ERROR: Module load completed but symbols could not be loaded for aswMonFlt.sys
A read error occured with the memory what has 2 possibilities
- A driver tried to read an invalid/wrong memory address
- A driver tried to read corrupted data in a memory address
Please test your memory using MemTest86+
Please check the voltage and frequency of the memory in the BIOS, note them and post them.
Code:
IRQL_NOT_LESS_OR_EQUAL (a)
An attempt was made to access a pageable (or completely invalid) address at an
interrupt request level (IRQL) that is too high. This is usually
caused by drivers using improper addresses.
If a kernel debugger is available get the stack backtrace.
Arguments:
Arg1: [COLOR=#FF0000]ffffc0010e20f8e8, memory referenced[/COLOR]
Arg2: 0000000000000002, IRQL
Arg3: [COLOR=#FF0000]0000000000000000[/COLOR], bitfield :
bit 0 : value [COLOR=#FF0000]0 = read operation[/COLOR], 1 = write operation
bit 3 : value 0 = not an execute operation, 1 = execute operation (only on chips which support this level of status)
Arg4: fffff80021089840, address which referenced memory
Run MemTest86+ to analyse your RAM.
MemTest86+ - Test RAM - Windows 7 Forums
Note
MemTest86+ needs to be run for
at least 8 passes for conclusive results. Set it running before you go to bed and leave it overnight. We're looking for
zero errors here. Even a single error will indicate RAM failure.