hicksville
New Member


- Messages
- 4
Hi all, I'm terribly confused and I hope someone can help me figure out what I"m doing wrong.
These are the steps I've taken-- OS Win 8, pre-installed by Acer.
1) Make recovery USB using the Acer recovery wizard, with the laptop in stock configuration.
2) Install msata as secondary drive
3) Go to Computer management and initialize the msata and format with GPT style. Format the drive, assign a drive letter. (I only see 1 partition). I did this as NTFS/default allocation size. Is this where I went wrong?
4) Remove the factory HDD (listed as HDD0 in BIOS)
5) Boot to BIOS
5a) in BIOS, disable secure boot.
5b) Go to legacy mode
5c) Set msata (HDD1 in BIOS) as #1 in boot order
6) boot to USB recovery drive, follow steps to restore from USB (clean install, make partitions as it wants)
7) remove USB, reboot.
error message-- no bootable device. I can basically load the USB again or the BIOS.
It's my first time with Win 8 and this kind of system. Thanks in advance for the advice.
These are the steps I've taken-- OS Win 8, pre-installed by Acer.
1) Make recovery USB using the Acer recovery wizard, with the laptop in stock configuration.
2) Install msata as secondary drive
3) Go to Computer management and initialize the msata and format with GPT style. Format the drive, assign a drive letter. (I only see 1 partition). I did this as NTFS/default allocation size. Is this where I went wrong?
4) Remove the factory HDD (listed as HDD0 in BIOS)
5) Boot to BIOS
5a) in BIOS, disable secure boot.
5b) Go to legacy mode
5c) Set msata (HDD1 in BIOS) as #1 in boot order
6) boot to USB recovery drive, follow steps to restore from USB (clean install, make partitions as it wants)
7) remove USB, reboot.
error message-- no bootable device. I can basically load the USB again or the BIOS.
It's my first time with Win 8 and this kind of system. Thanks in advance for the advice.
Last edited: