Multiple BSODs over past few months during general use.

[Salrion]

Hi there!

So I've been getting multiple BSODs over the past few months during general use. I've gotten several different stop error codes that I will list below, as well as uploading the zip file as per the posting instructions.

System service exception
Driver Irql not less or equal
Kmode exception not handled
System thread exception not handled
Page fault in nonpaged area,

Any and all help is very appreciated! I've tried updating drivers and running memtest, but the problems still persist.
Thanks in advance!

 

[axe0]

Hi Salrion,

Welcome to the 8forums.

It appears I cannot read the latest dump file, this could be caused by hardware damage. I think the hard drive might be causing this.
The 2nd most recent dump file says there might be memory corruption.

Diagnostic Test

RAM TEST

Run MemTest86+ to analyse your RAM. MemTest86+ - Test RAM - Windows 10 Forums

   Note

MemTest86+ needs to be run for at least 8 passes for conclusive results. Set it running before you go to bed and leave it overnight. We're looking for zero errors here. Even a single error will indicate RAM failure.

Diagnostics Test

HDD TEST

Run SeaTools to check the integrity of your HDD. SeaTools for DOS and Windows - How to Use - Windows 7 Help Forums

   Note

Do not run SeaTools on an SSD as the results will be invalid.

Run chkdsk Disk Check - Windows 7 Help Forums

 

[Salrion]

Thanks for the quick reply and the welcome!!

I'll go through your suggestions and get back to you with results hopefully sometime tomorrow!

 

[Salrion]

Update: Ran all available tests in Sea Tools with no errors. Will run memtest tonight after I get something to boot to it with from my friend later today.

 

[Salrion]

Alright so! I ran memtest overnight with 14 passes and no errors, so it looks like it's not the RAM. Is there anything else you think might be causing my BSODS from the dump files?

 

[Salrion]

Just finished running Chkdsk and it came back clean.