Alright so i seem to have found a solution to my problem.
It was simply the partition that was on the drive.
Just to clarify for folks reading this post in the future-
My Original issue was the Gateway Recovery was prompting me
to switch between Legacy and UEFI mode before the setup would...
@David Bailey
Do i need to have an OS installed to use the show key software or is it bootable?
As of right now i dont have an OS on it.
-Also
The arrangement of disks you have is the same i have. However, it will not let me boot off any but the 'System' Disks to start the install. If i try...
Thank you all for your replies.
When i get to the shop tomorrow I will try
suggestions that have been mentioned.
Where can i download a ISO of windows 8 64-bit?
And will it activate properly if it works?
@Ztrucker - For whatever reason, that hasn't crossed my mind. Thank you for that suggestion.
Thank you for your reply.
I have tryed that. I can get it to boot into the recovery, however when i try to initiate the recovery process it prompts me to restart in UEFI mode. When I boot the recovery in UEFI mode it tells me to restart it once again, in
Legacy mode. It keep going back and...
Hello everyone.
Long time viewer first time poster.
I'm having an issue with a Gateway NE56R31u.
The original hard drive has failed thus I am not able to utilize a restore partition.
And of course, my customer did not have restore disks made. Long story short,
I ordered the disks we needed...