Suddenly no POST and clicking sound. Weird!

malrats

New Member
Messages
9
Location
NJ
I installed Windows 8.1 earlier and had this (apparently common) watermark error on the desktop about SecureBoot having a problem.

I went into my BIOS, made sure it was enabled, and then set up some kind of "key" that the directions said to do. I clicked save and exit, and after that instead of booting into Windows, I'd be at a black screen, everything running inside my computer, and with my keyboard and mouse both turning on at the same time, then turning off at the exact same time 3-4 seconds later along with a quiet sort of clicking sound inside the computer. Over and over, looping endlessly.

I opened it up, checked connections, removed parts and tried booting with each thing moved. It only finally booted when I removed my graphics card and plugged my monitor into the onboard DVI port.

After that I shut down, put my graphics card back in, booted with the monitor still plugged into the onboard DVI, and it booted without issue. I then plugged the monitor back into the graphics card DVI port and rebooted. Went back to the clickly flashy no-POST cycle. After repeating this whole process a few times, I realized that when it's in that cycle, if I just plug the monitor into the onboard DVI port, I get the POST beep and everything boots up.

Eventually I just did some messing around in the BIOS, turned SecureBoot off as well as disabled onboard graphics and then booted the PC back up with the monitor in the graphics card DVI port. It boots fine now, I've rebooted 5-6 times now and it goes into Windows 8.1 no problem.

Does anyone have ANY idea of what might have caused this? I'm afraid it's going to come back.
 

My Computer

System One

  • OS
    Windows 8.1 Pro
    Computer type
    PC/Desktop
    System Manufacturer/Model
    Self built
    CPU
    i5 4670k
    Motherboard
    Gigabyte Z87X-D3H
    Memory
    16GB
    Graphics Card(s)
    MSI GTX 770
    Screen Resolution
    1920x1080
    Browser
    Firefox
    Antivirus
    avast!
Suddenly no POST and clicking sound

Personally, I would backup all important data and even try to create a system backup while you still can because it really sounds like your hard drive may be going south. Unfortunately you can run diagnostic until the cows come home but that clicking sound is indicative of an impending mechanical failure and the only hardware that sings that song is your hard drive (based on my experience). Good luck and I hope those clicks do not return anytime soon.
 

My Computer

System One

  • OS
    Windows 8.1
    Computer type
    PC/Desktop
    CPU
    Intel G2020
    Motherboard
    ASRock B75M-DGS R2.0
    Memory
    8GBs @ 1333 MHz
    Hard Drives
    Samsung 840 EVO
    PSU
    400w
    Internet Speed
    57/11
I had both hard drives and my DVD drive unplugged during an attempted boot. Still a clicky sound.

So I don't think it was the hard drive. I honestly get the feeling it isn't actually a hardware issue, given just how much of a coincidence it would have to be that this happened RIGHT on schedule with an 8.1 upgrade.
 

My Computer

System One

  • OS
    Windows 8.1 Pro
    Computer type
    PC/Desktop
    System Manufacturer/Model
    Self built
    CPU
    i5 4670k
    Motherboard
    Gigabyte Z87X-D3H
    Memory
    16GB
    Graphics Card(s)
    MSI GTX 770
    Screen Resolution
    1920x1080
    Browser
    Firefox
    Antivirus
    avast!
I had both hard drives and my DVD drive unplugged during an attempted boot. Still a clicky sound.

So I don't think it was the hard drive. I honestly get the feeling it isn't actually a hardware issue, given just how much of a coincidence it would have to be that this happened RIGHT on schedule with an 8.1 upgrade.

Ok, thanks for that but please let us know what the source of the clicking is/was because I'm thinking its going to be something very special that I have never encountered before. Good luck!
 

My Computer

System One

  • OS
    Windows 8.1
    Computer type
    PC/Desktop
    CPU
    Intel G2020
    Motherboard
    ASRock B75M-DGS R2.0
    Memory
    8GBs @ 1333 MHz
    Hard Drives
    Samsung 840 EVO
    PSU
    400w
    Internet Speed
    57/11
I had both hard drives and my DVD drive unplugged during an attempted boot. Still a clicky sound.

Just a followup comment that the above proves conclusively that it cannot be an 8.1 upgrade issue.
 

My Computer

System One

  • OS
    Windows 8.1
    Computer type
    PC/Desktop
    CPU
    Intel G2020
    Motherboard
    ASRock B75M-DGS R2.0
    Memory
    8GBs @ 1333 MHz
    Hard Drives
    Samsung 840 EVO
    PSU
    400w
    Internet Speed
    57/11
I then plugged the monitor back into the graphics card DVI port and rebooted. Went back to the clickly flashy no-POST cycle.

So, I went back and read you rpost thoroughly and I did not see where you ever mention the unplugging of all hard drives until your second post which was most informative. However, I did see the above comment that peaked my interest again and that somewhat isolated the condition to the exact configuration you specified in same. With that said, I offer this for your review and reference:

Monitor makes a clicking noise
 

My Computer

System One

  • OS
    Windows 8.1
    Computer type
    PC/Desktop
    CPU
    Intel G2020
    Motherboard
    ASRock B75M-DGS R2.0
    Memory
    8GBs @ 1333 MHz
    Hard Drives
    Samsung 840 EVO
    PSU
    400w
    Internet Speed
    57/11
The clicking sound is not coming from the monitor.

It's a sound that I think the PC always made one time naturally when first clicking reboot.

Do you think it was just a BIOS issue then?

What would cause it to only boot with the monitor plugged into the onboard DVI and not the graphics card? And like I said, it works now.
 

My Computer

System One

  • OS
    Windows 8.1 Pro
    Computer type
    PC/Desktop
    System Manufacturer/Model
    Self built
    CPU
    i5 4670k
    Motherboard
    Gigabyte Z87X-D3H
    Memory
    16GB
    Graphics Card(s)
    MSI GTX 770
    Screen Resolution
    1920x1080
    Browser
    Firefox
    Antivirus
    avast!
What would cause it to only boot with the monitor plugged into the onboard DVI and not the graphics card?

Monitor unable to establish communicate with graphics card. Clicking would have been the monitor looking/switching inputs to see if a good signal is/was detected. That's it for me. Good luck.
 

My Computer

System One

  • OS
    Windows 8.1
    Computer type
    PC/Desktop
    CPU
    Intel G2020
    Motherboard
    ASRock B75M-DGS R2.0
    Memory
    8GBs @ 1333 MHz
    Hard Drives
    Samsung 840 EVO
    PSU
    400w
    Internet Speed
    57/11
Back
Top