Windows 8 and 8.1 Forums

Windows 8.1 BSOD

  1. #1


    Posts : 4
    Windows 8.1

    Windows 8.1 BSOD


    Hi everyone, I'm new to this forum, and I'm here to ask for help. Everytime I boot my pc on startup i get BSOD Irql_not_less_or_equal. It's very frustrating and annoying. So i hope I will be able to fix this problem. I don't really understand much in computers, but I'll do what I can. Thanks.
    Last edited by AivisLT; 30 Oct 2015 at 08:33.

      My System SpecsSystem Spec

  2. #2



    BSOD Kernel Dump Analyst
    Posts : 2,274
    Windows 10 Pro
      My System SpecsSystem Spec

  3. #3


    Posts : 4
    Windows 8.1


    Quote Originally Posted by axe0 View Post
    Added the DMP, sorry.
      My System SpecsSystem Spec

  4. #4



    BSOD Kernel Dump Analyst
    Posts : 2,274
    Windows 10 Pro


    Please visit Windows Update and install every update available, it may take a couple of times to get them all.

    Please uninstall Avast while troubleshooting
    Code:
    *** WARNING: Unable to verify timestamp for aswMonFlt.sys
    *** ERROR: Module load completed but symbols could not be loaded for aswMonFlt.sys
    A read error occured with the memory what has 2 possibilities
    • A driver tried to read an invalid/wrong memory address
    • A driver tried to read corrupted data in a memory address

    Please test your memory using MemTest86+
    Please check the voltage and frequency of the memory in the BIOS, note them and post them.
    Code:
    IRQL_NOT_LESS_OR_EQUAL (a)
    An attempt was made to access a pageable (or completely invalid) address at an
    interrupt request level (IRQL) that is too high.  This is usually
    caused by drivers using improper addresses.
    If a kernel debugger is available get the stack backtrace.
    Arguments:
    Arg1: ffffc0010e20f8e8, memory referenced
    Arg2: 0000000000000002, IRQL
    Arg3: 0000000000000000, bitfield :
        bit 0 : value 0 = read operation, 1 = write operation
        bit 3 : value 0 = not an execute operation, 1 = execute operation (only on chips which support this level of status)
    Arg4: fffff80021089840, address which referenced memory



    Windows 8.1 BSOD Diagnostic Test Windows 8.1 BSOD
    RAM TEST

    Run MemTest86+ to analyse your RAM. MemTest86+ - Test RAM - Windows 7 Forums

    Note   Note


    MemTest86+ needs to be run for at least 8 passes for conclusive results. Set it running before you go to bed and leave it overnight. We're looking for zero errors here. Even a single error will indicate RAM failure.
      My System SpecsSystem Spec

  5. #5


    Posts : 4
    Windows 8.1


    Quote Originally Posted by axe0 View Post
    Please visit Windows Update and install every update available, it may take a couple of times to get them all.

    Please uninstall Avast while troubleshooting
    Code:
    *** WARNING: Unable to verify timestamp for aswMonFlt.sys
    *** ERROR: Module load completed but symbols could not be loaded for aswMonFlt.sys
    A read error occured with the memory what has 2 possibilities
    • A driver tried to read an invalid/wrong memory address
    • A driver tried to read corrupted data in a memory address

    Please test your memory using MemTest86+
    Please check the voltage and frequency of the memory in the BIOS, note them and post them.
    Code:
    IRQL_NOT_LESS_OR_EQUAL (a)
    An attempt was made to access a pageable (or completely invalid) address at an
    interrupt request level (IRQL) that is too high.  This is usually
    caused by drivers using improper addresses.
    If a kernel debugger is available get the stack backtrace.
    Arguments:
    Arg1: ffffc0010e20f8e8, memory referenced
    Arg2: 0000000000000002, IRQL
    Arg3: 0000000000000000, bitfield :
        bit 0 : value 0 = read operation, 1 = write operation
        bit 3 : value 0 = not an execute operation, 1 = execute operation (only on chips which support this level of status)
    Arg4: fffff80021089840, address which referenced memory



    Windows 8.1 BSOD Diagnostic Test Windows 8.1 BSOD
    RAM TEST

    Run MemTest86+ to analyse your RAM. MemTest86+ - Test RAM - Windows 7 Forums

    Note   Note


    MemTest86+ needs to be run for at least 8 passes for conclusive results. Set it running before you go to bed and leave it overnight. We're looking for zero errors here. Even a single error will indicate RAM failure.
    When the BSOD appeared I sent my PC to the place where I bought It and they ran all the tests and said that all details were fine (RAM and others). After some time BSOD appeared again so I don't know what to do..
      My System SpecsSystem Spec

  6. #6



    BSOD Kernel Dump Analyst
    Posts : 2,274
    Windows 10 Pro


    What tests have they performed?
      My System SpecsSystem Spec

  7. #7


    Posts : 4
    Windows 8.1


    Quote Originally Posted by axe0 View Post
    What tests have they performed?
    I saw a program of Memtest86 in the recycle bin. They tested GPU, CPU, RAM, Hard Drive and said that those parts are fine. Oh and I went outside to take a break when I returned I turned my PC on and I got the BSOD of PAGE_FAULT_IN_NONPAGED_AREA
      My System SpecsSystem Spec

  8. #8



    BSOD Kernel Dump Analyst
    Posts : 2,274
    Windows 10 Pro


    MemTest86 or MemTest86+
    MemTest86+ is better
      My System SpecsSystem Spec

Windows 8.1 BSOD
Related Threads
Hey guys , So I've finally made the jump from 7 to windows 8.1 ,fresh install all updates done and drivers correct , but every now and then I am getting BSOD Windows 8.1 Kernel Security Check Failure on Windows Your Help would be much appreciated ;) DTG SF file uploaded ;)
hello everyone, today i had several bsod Kernel Security Check Failures in my windows 8.1 pc and i want your help.. (i must say that i have all the ms updates done) i have attached the zip file thanks in advance
Hello everyone, I just got my Lenovo Y70 from Amazon, I got a BSOD in the first 15 minutes, so I assumed auto updates were installing something nasty that would go away once they were done. So they're done, but the BSOD keeps on ticking. The machine is 2 days old. Nothing has been installed...
I have a clients Laptop (Asus X550C) running Windows 8 and the first error I had was 0xc0000034, having a look around I tried some fixes but none worked, eventually I was left with the following error: 0xc0000001. As of now I am stuck here, I have a backup of the main files the client needs but do...
We have a computer that went BSOD this morning on startup. (Windows 8.1 PRO 64 bit) From what we can tell, nothing has changed since last Tuesday/Wednesday. It was shut down every night and restarted everyday for the last 5 days. This morning, it starts up through normal boot process, shows...
Hi, Please help. I am at wits end. I have tried with a new harddisk, took out my graphics card, checked my memory, they all seemed fine. My computer always run into a quick BSOD during the first boot and I am unable to see the error message and it restarts back to BIOS followed by a successful...
Hi, my problem with my laptop is Windows 8 BlueScreen and also Restart my laptop Without display BlueScreen and sometime this happened for more than 1 time regularly. this problem is happend Sometimes more than twice a day, when i'm doing regular things like reading a .pdf or watching a movie...
Eight Forums Android App Eight Forums IOS App Follow us on Facebook