Hi JawnMusic ^_^,
I am sorry for the delay caused. Softwaremaniac must be busy and hence the delay. Let me help you out in the mean time ^_^. I have analysed your dump files and below has been provided an analysis of the same for informative purposes :-
In all the dump files which I analysed, this same operation is causing the BSOD. In this one, we are trying to move the value of the register RAX and RDX multiplied by 4. Unfortunately, the dump file did not save the contents of the Page Table Entry highlighted in orange.
2: kd> .trap 0xfffff88003d11fa0
NOTE: The trap frame does not contain all registers.
Some register values may be zeroed or incorrect.
rax=fffff880037e2000 rbx=0000000000000000 rcx=fffffa800888b078
rdx=0000000000004012 rsi=0000000000000000 rdi=0000000000000000
rip=fffff8800fe60dc6 rsp=fffff88003d12138 rbp=fffffa800888c030
r8=0000000000000002 r9=fffff8800fff9470 r10=0000000000000000
r11=fffff8800ffebe8f r12=0000000000000000 r13=0000000000000000
iopl=0 nv up ei ng nz na po nc
fffff880`0fe60dc6 8b0490 mov eax,dword ptr [rax+rdx*4] ds:fffff880`037f2048=????????
But, this is the scenario with all of the dump files so I would think that this is most likely a software fault. Let's check the time stamp of the ATI Driver -
It is dated to 2014. I must tell you that for Laptops, it is strongly suggested to use the Video Drivers provided by the manufacturer only since they do special tweaking so that the Graphics Switching can work.
2: kd> lmvm atikmdag
start end module name
fffff880`0fe0c000 fffff880`10e76000 atikmdag T (no symbols)
Loaded symbol image file: atikmdag.sys
Image path: \SystemRoot\system32\DRIVERS\atikmdag.sys
Image name: atikmdag.sys
Timestamp: Sun Oct 05 00:24:23 2014 (5430425F)
Translations: 0000.04b0 0000.04e4 0409.04b0 0409.04e4
Now, before running any tools below as per the instructions, make sure that you are BOOTED in SAFE MODE with Networking. This is to make sure that you do not face any further problems.
- Kindly download the Display Driver Uninstaller from **LINK1**.
- Once you are booted into Safe Mode, run the DDU and then clean the driver. Reboot the system and once it has booted again, boot into the Safe Mode with Networking.
- Go to this **LINK** and download the Video BIOS Update. You can check the Fixed list of things and that includes BSOD issues as well . Once it has downloaded, follow the instructions which are given below on the same link and then flash the Video BIOS. Note that flashing BIOS is a very risky and a single mistake could ruin the system physically. Make sure that your system is plugged in.
- Now once the Video BIOS Update is done, make sure that you are still in Safe Mode in Networking and then download the driver from this **LINK**. Once it is downloaded, follow the instructions which are given below on the same link.
- Reboot your machine in normal mode.
Let me know how it goes ^_^. I have tried my best to be precise and clear, yet in case of any doubt in the instructions, kindly do not hesitate to ask before proceeding further ^_^.